Dynapac F1800C, Operation & Maintenance Manual

Page: 285 / 348

F 60.18 11
Pump distribution gear (5)
-
Check the oil level
at the sight
glass (A) (at the side of the
gear housing).
A
The oil level must be up to the centre of
the sight glass.
For
filling
with oil:
- Unscrew the filler screw (B).
- Fill oil in through the filling port until the
required filling level is achieved at the
sight glass (A).
- Screw in the filler screw (B) again.
m
Make sure to clean the screw and the vi-
cinity of the drain bore!
Oil change:
- Place the end of the oil drain port hose
(C) in the collection container.
- Remove the screw cap with a wrench
and allow the oil to drain completely.
- Replace the screw cap and tighten
properly.
- Fill in the oil of specified quality
through the filling port on the gearbox
(B) until the oil level rises to the centre
of the sight glass (A).
A
The oil should be changed when at oper-
ating temperature.
A
B
C