Dynapac DTR75D, Operating Instruction

Page: 101 / 122

7. Unscrew the filter housing.
8. Take out the old filter element and clean the filter housing.
9. Clean the thread on the filter housing.
10. Reassemble the filter housing with a new filter element and a
new O-ring.
11. Tighten the filter housing.
12. Clean the area around the cover (2).
13. Remove the screws (1) and take off the cover.
14. Remove the suction filter (4) and replace it.
15. Attach the cover with a new seal (3) and fasten the screws.
16. Tighten the screws crosswise in the correct sequence
(1 - 10), tightening torque: 15 Nm (11 ft·lbf).
17. Then retighten the screws in the same sequence, tightening
torque: 35 Nm (26 ft·lbf).
Replacing the hydraulic oil filter
B-834-0312
Fig. 114
Replacing the suction filter
1
2
3
4
B-834-0217
Fig. 115
3 10 1 7
4 9 8 2
6 5
15 Nm 35 Nm
B-834-0313
Fig. 116
Maintenance – Every 2 years / every 500 operating hours
DTR75D 101