Dynapac CA 152, Instruction Manual

Page: 60 / 119

Operation
ICA152-4EN3.pdf 2012-06-12
Vibration
Amplitude/frequency - Changeover
24
Fig. Instrument panel
24. Amplitude selector Low/0/High
There are two drum vibration settings. Use the switch
(24) to adjust.
Turn the knob to the left for low amplitude/high
frequency and to the right for high amplitude/low
frequency.
Setting the amplitude may not be performed
when vibration is in operation.
Switch the vibration off first and wait until
vibration stops before setting amplitude. Setting the amplitude may not be performed
when vibration is in operation.
Switch the vibration off first and wait until
vibration stops before setting amplitude.
Manual vibration - Switching on
38
Fig. Control panel
38. Switch, vibration On/Off
Never activate vibration when the roller is
stationary. This can damage both the surface and
the machine. Never activate vibration when the roller is
stationary. This can damage both the surface and
the machine.
Engage and disengage vibration using the switch (38)
on the front of the forward/reverse lever.
Always switch off vibration before the roller comes to a
standstill.
The engine does not stop if the parking brake is
activated.
50