Dynapac 10000333x0A000001, Instruction Manual

Page: 100 / 105

Maintenance - 2000h
ICC1200C-1EN3.pdf 2012-05-16
Drum - Oil change
Fig. Drum, vibration side
1. Drain plug
1
Take great care when draining the fluid. Wear
protective gloves and goggles. Take great care when draining the fluid. Wear
protective gloves and goggles.
Place the roller on a level surface and drive it slowly
until the drain plug (1) is straight down.
Switch off the engine and activate the parking
brake. Switch off the engine and activate the parking
brake.
Place a receptacle that will hold at least 7 liters
(7.4 quarts) under the plug. Collect the oil and
dispose of it properly. Place a receptacle that will hold at least 7 liters
(7.4 quarts) under the plug. Collect the oil and
dispose of it properly.
Remove the plug and allow all the oil to run out. See
under the heading 'Every 500 hours of operation' for
filling oil.
Water tank - Draining
1
Fig. Pump system
1. Water filter
Remember that there is a risk of freezing during
the winter. Empty the tank, pump and lines. Remember that there is a risk of freezing during
the winter. Empty the tank, pump and lines.
The easiest way to empty the water tank is to open the
drain cock on the water filter (1). (There is also a drain
plug under the water tank).
92