Dynamix IAD -162 Gateway
2.1.4.3.1 Proxy mode
Proxy mode means that there will be an intermediate Proxy Server between
Dynamix IAD -162 Gateway and the remote entity. While operating at this mode,
Dynamix IAD -162 Gateway will first register to the Proxy Server located at the ISP
side. For the following operation, it sends the INVITE message to the Proxy Server
once you initiate a session. Then the Proxy server will forward the INVITE message
to the right place. And the Response message from the remote entity will be
forwarded back to you via Proxy server.
Step 1.
Set Proxy Mode, using “sip” command
usr/config$ sip –mode 1
Mode 0 is for Peer-To-Peer mode, while mode 1 is for Proxy mode.
Step 2.
You must specify Proxy address obtained from your service provider. And the
Proxy address can be IPv4 address as well as DNS name.
Several important SIP parameters are listed below when setting proxy
mode:“–px”, ”–line1”.
For example:
usr/config$ sip –px
210.68.222.33
-line1
12345
In this case is to set proxy IP address as “210.68.222.23”, line number as
“12345”.
Step 3.
You must configure the accounts using “security” command.
An example is demonstrated below:
usr/config$ security –line 1 –name 12345 –password 12345
This is to set username (userid) as “12345”, password as “12345” into line1,
which means line1 can accept incoming calls after successfully registered to
Proxy server.
Note:
1. Please contact with your Proxy vendor to obtain user account information.
2. If no need to enter password, user also has to set security information, please
set “name” the same with line number.
2.1.4.3.2 Peer-to-Peer Mode
Peer-to-Peer Mode allows users to call other VoIP devices without the proxy
- 20 -
