Dynamax Dynamet 5, User Manual

Page: 22 / 83

Dynamet 5
21

Plumb the mast by adjusting the south and northeast facing legs. Loosen the slide collar
bolt on the south facing leg. With the level on the south side of the mast, adjust the leg so
the level reads plumb, and then tighten the bolt. Repeat the same procedure for the
northeast facing leg with the level on the east side of the mast.

Drive the rebar stakes through the holes in the feet in to the ground surface to secure
tripod.

Loosen the sent screws in the two-brass ground lugs attached to the center bracket of
the tripod. Strip 1” of insulation from the other end of the 4AWG wire and inset it into the
lower gr
ound lug. Strip 1” of insulation from one end of the 12AWG wire and insert it into
the upper ground lug. Tighten the setscrews. Attach the other end of the 12AWG wire to
the ground lug of the enclosure.

Attach 019ALU cross-arm to the mast. Slide the center NU-RAIL connector of the cross
arm down the cross arm mount until it rests on top of the bell reducer. Maintain the center
of the NU-
RAIL connector about 113” above the ground surface. Orient cross arm mount
Lightning
rod