Installing the LCD Assembly
Install the LCD assembly according to the following procedures:
1.
Place the logic upper assembly upside down so that the bottom is facing up.
2.
Rotate the LCD hinges to a 180-degree angle and seat the LCD assembly in the correct position
on the logic upper assembly, and the cables must be placed inside the hook of hinge
bracket
□
,4
3.
Tighten the six M2.5×5 screws to secure the LCD assembly to the logic upper assembly as
shown inFigure4- 18.
□
,3
4.
Route and secure the W-LAN cables and edp cable in the routing channels on the logic upper
assembly as shown in Figure4- 17
□
,2
□
,1
Summary of Contents for Satellite C50-K
