dynabook Satellite C50-K, Manual

Page: 13 / 46

Installing the thermal module
Install the fan and thermal module according to the following procedures:
1. Seat the fan in the correct position on the logic upper assembly and insert the fan connector
□
9
and tuck the fan cable into the fan hook
□
10 . as shown in Figure4- 5
2. Tighten the two M2 x 3
□
2 screws to secure the fan to the logic upper assembly, as show in
Figure4- 3
3. Check the greasy is attached on the thermal module as shown in Figure4- 6
4. Place the thermal module in the correct position on the motherboard
5. Tighten the three M2 x 3 screws according to the number sequence (3->4->5) indicated in
Figure4- 3 to secure the thermal module to the motherboard.
6. For the w-lan cable routing, tuck the w-lan cable into the fan hook
□
11 , and wlan cable connector
insert the wlan card
□
12 . Finally, paste wlan mylar on the w-lan module
□
13 as shown in Figure4-
5
Figure4- 1 Fan Cable and W-lan Cable