- 3 -
M965706 Rev. 1.0 (3/17)
2
3
4
6
5
POP-UP DRAIN
REMOVE MOUNTING WASHERS
AND LOCKNUT
ATTACH DRAIN FROM
BELOW FIXTURE
FLANGE GASKET AND POP-UP KNOB
TIGHTEN LOCKNUT
• Remove CLEAR PLASTIC COVER
(1)
.
Fig. A.
• Remove FOAM SPACER
(2)
from
under DRAIN POP-UP
(3)
.
Fig. A.
• Tighten TAILPIECE
(4)
on DRAIN BODY
before installing DRAIN BODY.
Fig. B.
• Thread LOCKNUT
(1)
counter-clockwise
and remove from drain body. Remove
PLASTIC WASHER
(2)
and pull off
RUBBER CONE WASHER
(3)
Fig. A.
• Drop DRAIN BODY
(4)
through sink drain
hole. Make sure WHITE FOAM GASKET
(5)
is under flange of DRAIN BODY
(4)
.
Fig. B.
Note:
No plumber’s putty or caulk is required.
• The CABLE ATTACHMENT POINT
(6)
must
face towards the rear of the SINK.
Fig. B.
• From under side of SINK install
RUBBER CONE WASHER
(3)
,
PLASTIC WASHER
(2)
and
LOCKNUT
(1)
onto DRAINBODY
(4)
.
Note:
The CABLE ATTACHMENT
POINT
(5)
must face towards
the rear of the SINK.
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET
(3)
is fully compressed
and not visible.
Fig. A
.
• POP-UP KNOB
(1)
must be fully down.
Fig. B.
2
3
1
DRAIN
BODY
4
Fig.
A.
Fig.
B.
REAR OF
SINK
4
5
6
SINK
DRAIN
HOLE
1
3
2
Fig. A
Fig. B
WHITE FOAM
GASKET
NOT VISIBLE
DRAIN
FLANGE
DOWN
UP
1
Fig. A
Fig. B
1
5
3
2
4
1
• Tighten LOCKNUT
(1)
firmly with
Adjustable Wrench or Channel Locks.
