- 2 -
M965706 Rev. 1.0 (3/17)
1
• Install SEAL
(1)
into groove of FAUCET BASE
(2)
.
• Feed FAUCET SUPPLY TUBES
(5)
and SHANK
(3)
and DRAIN CABLE ASSEMBLY
(9)
through
mounting hole of lavatory or mounting surface.
• From below, Install RUBBER SEAL with RETAINING WASHER
(4)
and LOCKNUT
(6)
onto faucet
SHANK
(3)
. Before final tightening, faucet should be seated flush on mounting surface. Adjust
faucet so that it is centered and covers mounting hole. Tighten LOCKNUT
(6)
using a 15mm or
adjustable wrench. Do not over tighten.
• Installation is the same for VESSEL FAUCET
(8)
.
INSTALL FAUCET (LAVATORY AND VESSEL FAUCETS)
CAUTION
Turn off hot and cold water
supplies before beginning.
1
3
2
7
MOUNTING
SURFACE
4
5
9
6
8
