Appendix
Troubleshooting
A-4
SpycerBox Ultra/Flex | Hardware Guide | Version 3.1
Rohde & Schwarz DVS GmbH
An alarm is sounded
and the alarm LED is
off. The alarm cannot
be switched mute
with the mute button.
OR
At start-up the system
is not able to initialize
a disk set.
A hard disk or a hard
disk carrier got loose/
jammed (e.g. after
transport) or is not
mounted correctly.
Shut down the system as described
in section “Shutting Down the Sys-
tem” on page 4-5. Then perform the
following: Pull all disk carriers partial-
ly out of the chassis and afterwards
install them again. See to it that they
are pulled out and reassembled cor-
rectly as described in section “Re-
placing a Hard Disk” on page 5-5.
After that start the system again.
A hard disk of the
hard disk array is de-
fective.
Replace the defective disk as ex-
plained in section “Hard Disk Mainte-
nance” on page 5-2.
A RAID controller is
defective.
If you can rule out the above men-
tioned causes, a RAID controller may
be defective. Before attempting to
exchange a RAID controller (see sec-
tion “Controller Maintenance” on
page 5-12) contact the R&S DVS ser-
vice department.
Error
Cause
Solution