DVS Atomix LT, Installation Manual

Page: 37 / 72

3-3
Installation
3
2
1
I
4
A
The computer system is now ready for the installation and you have to
proceed with the checking of the panels for their correct jumper set-
tings.
Jumper Settings of the Audio and RS-422 Panel
When installing the audio and RS-422 panel as the audio panel #1 (see
section “Note About the Audio Setup” on page 2-10), up to four stereo
channels of AES/EBU or three stereo channels of AES/EBU and one LTC
in- and output can be transmitted. This signal configuration has to be
configured via jumper settings on one of the printed circuit boards
mounted to the audio and RS-422 slot panel.

Before installing the audio and RS-422 panel please check whether
the jumpers on the printed circuit boards are set to your desired
configuration and, if appropriate, adjust them:
Figure 3-1: Jumper settings for audio (audio panel #1)
After checking and, if appropriate, adjusting the jumpers you can con-
tinue the installation by checking the jumpers of the audio panels (if
available).
In a setup that contains this panel as well as one of the audio
panels (see section “Audio Panel” on page 2-12), it is recom-
mended to install it as audio panel #2 (see section “Note About
the Audio Setup” on page 2-10). Then the jumpers should be
set as the indicated in the left drawing (figure above, 4th audio
channel activated).
LTC activated
4th audio
channel activated