DVS Atomix LT, Installation Manual

Page: 17 / 72

1-7
Introduction
1
2
3
I
4
A
Flat cable connectors are equipped with a locking mechanism to pre-
vent them from becoming disconnected after they were plugged in.
To unplug the connector use your index finger and thumb to press the
locking wings together.
Figure 1-1: Unplugging flat cables
Then you can easily remove the connector.
Breakout Boxes
There are several breakout boxes optionally available for Atomix LT
(not for Atomix LT 4 BNC) to replace the breakout cables and reduce
the amount of panels. You can adapt the overall configuration to your
personal needs. To connect to some of the breakout boxes an interface
slot panel may be required which will be included in the delivery.
For more information about the different types of breakout boxes avail-
able for Atomix LT please contact your local vendor or DVS directly.
Don’t use any force to disconnect flat cable plugs, otherwise
the socket on the board may be damaged or even break off.