DVS Atomix LT, Installation Manual

Page: 28 / 72

2-10
Atomix LT Installation Guide
2.3 Overview of the Panels
To provide all the connection possibilities of the board at a computer
casing, several panels may have been delivered with the board. This
section provides an overview of the panels available for Atomix LT.
2.3.1 Note About the Audio Setup
Atomix LT provides up to 16 channels digital audio (AES/EBU).
With 16 channels digital audio up to two panels for audio can be deliv-
ered with the Atomix LT:
– One that has to be connected to the AUDIO 1-8/LTC connector on
the Atomix LT board (in this guide referred to as ’audio panel #1’).
– One that has to be connected to the AUDIO 9-16 connector on the
Atomix LT board (referred to as ’audio panel #2’).
There are two types of panels for audio available:
– One with analog and digital audio connections (called ’audio
panel’, see section “Audio Panel” on page 2-12).
– One with digital audio plus RS-422 connection (called ’audio and
RS-422 panel, see section “Audio and RS-422 Panel” on
page 2-11).
The following tables show the possible combinations of the two types
of panels and their recommended installations:
Please note that the panels are optionally available and will be
part of your delivery only if you have ordered them.
For Atomix LT 4 BNC the slot panels as mentioned below are
available. However, the Atomix LT 4 BNC provides only
8 channels digital audio. So, whichever audio panel you have
received, it has to be connected to the AUDIO 9-16 connector
on the Atomix LT board (i.e. as audio panel #2). For Atomix LT
4 BNC the DVS SDK provides special defines to configure the
audio channels of this connector.
Delivered Panels Install as…
1 × audio panel audio panel #1 (AUDIO 1-8/LTC)
1 × audio panel audio panel #2 (AUDIO 9-16)