DVS Atomix LT, Installation Manual

Page: 29 / 72

2-11
Overview
2
1
3
I
4
A
When only one panel for audio has been delivered to you, it should al-
ways be set up as audio panel #1 (i.e. connected to AUDIO 1-8/LTC).
2.3.2 Audio and RS-422 Panel
The audio and RS-422 panel provides a DB-25 connector for digital au-
dio (AES/EBU) and LTC signals as well as a DB-9 connector for a stan-
dard RS-422 connection for remote control.
To the DB-25 connector you can connect a breakout cable providing
eight XLR connectors to interface directly with audio devices. The pin-
out of the RS-422 port can be can be switched between master and
slave mode in the software. Pin-outs of the DB-9 and DB-25 connectors
can be found in section “Signal In- and Outputs” on page A-7.
Figure 2-5: Panel with audio and remote control connections
Delivered Panels Install as…
1 × audio panel audio panel #1 (AUDIO 1-8/LTC)
1 × audio and RS-422 panel audio panel #2 (AUDIO 9-16)
Digital Audio (AES/EBU)
Remote In/Out