Dürr Technik SICOLAB med, Installation And Operating Instructions Manual

Page: 19 / 36

1018100100L02 1907V005
17
8 Requirements
8.1 Installation/setup room
The room chosen for set up must fulfil the fol-
lowing requirements:
– Closed, dry, well-ventilated room.
– Should not be a purpose-made room (e. g.
boiler room or wet room).
– Set up the unit on a clean, level and sufficient-
ly stable surface (take the weight of the unit
into account).
– Set up or install the unit so that the type plate
can be easily read and the unit is easily acces-
sible for operation and maintenance.
– Set up the units so that the socket to which
the units is connected is easily accessible.
– Room temperature: +5°C to +40°C.
– Ensure that there is sufficient distance to the
wall so that the air can flow in and out without
any obstruction.
The air is filtered when it is sucked in.
This does not alter the composition of
the air. The source of the air taken in
should be free of any harmful substances
(e.g. do not draw in air from an under-
ground garage or directly next to a suc-
tion machine).
NOTICE
Risk of overheating due to insuffi-
cient ventilation
The units generates heat. Possibility of
heat damage and/or reduced service life
of the unit.
i
Do not cover the unit.
i
Air must be able to flow in and out un-
obstructed.
i
Ventilation openings must be suffi-
ciently large.
i
Installed units may require an inde-
pendent ventilation system in unfa-
vourable cases.
The unit must only be operated on a stable,
even base. The unit must not be used as a
climbing aid. Danger of breakage!
7 Tools required
–
Nm
Torque wrench
– Hexagon keySW12
– Allen wrench SW 3
Assembly
EN