2142100002L02 1908V007
23
Assembly
has been inserted in the unit incorrectly, take
it out again and re-insert it properly.
7.6 Electrical connections
Safety when making electrical connections
i
The device must only be connected to a cor-
rectly installed power outlet.
i
Do not place non-fixed multi-socket units on
the floor. Follow the requirements in sec-
tion 16 of IEC 60601-1 (EN 60601-1).
i
Do not operate any other systems using the
same multiple socket.
i
Make sure that none of the electrical cables
leading to the unit are under any mechanical
tension.
i
Before initial start-up check that the mains
supply voltage and the voltage stated on the
type plate match (see also "4. Technical
data").
Connecting the unit to the mains supply
The unit has no main power switch. For
this reason it is important that the unit is
be set up in such a way that the plug can
be easily accessed and unplugged if re-
quired.
Requirements:
– Properly installed power outlet close to the
unit (observe the max. mains cable length)
– Easily accessible power outlet
Installing the unit with the wall mounting
bracket
The unit can be mounted on a wall with the wall
mounting bracket (see "3.3 Optional items").
For installation refer to the installation in-
structions for the wall mounting (order
number 9000-618-162)
7.3 Removing the protective film
from the touch screen
i
Grasp one corner of the protective touch
screen film and peel it off carefully.
7.4 Attaching the stylus
i
The stylus is held on the unit by a magnet.
Place the stylus in the indentation provided.
7.5 Checking the memory card
NOTICE
Loss of image data due to unex-
pected insertion or removal of the
memory card
i
Only insert or remove the memory
card when unit is switched off.
i
Check whether the memory card has been in-
serted in the unit correctly. If the memory card
EN
