Dürkopp Adler 868-M, Operating Instructions Manual

Page: 116 / 168

Setup
114 Operating Instructions 868-M - 01.0 - 12/2020
Protection parts
Fig. 76: Completing the tabletop (4)
The rubber corners (5) serve the following functions:
• Protecting the tabletop and the machine head
• Ensuring that the machine head is securely seated in the
tabletop cutout
Information
The plastic shims (4) are not required unless the machine head
is supposed to be set up in a slanted position (

p. 119 ).
Do NOT insert the plastic shims (4) if the machine head is supposed
to be set up straight inside the tabletop cutout.
To prepare the tabletop cutout for the machine head:
1. Insert the plastic shims (4) into the front corners inside the
tabletop cutout if the machine is supposed to be set up in a
slanted position.
The tall edge must face towards the rear, while the flat edge
must face forward.
2. Insert the rubber corners (5) into the front corners in the tabletop
cutout.
3. Insert the lower hinge parts (3) into the hinge slots in the
tabletop cutout on the rear left and right.
(3) - Lower hinge part
(4) - Plastic shim (5) - Rubber corners
④ ⑤
④ ③