Troubleshooting
Operating Instructions 650-10 - 03.0 - 08/2016
141
2102
Error
X-axis stepper motor:
• Stepper motor not moving
freely or blocked
• Encoder cable not connec-
ted or defective
• Stepper motor cable not
connected or defective
• Encoder defective
• Stepper motor defective
• Remove the cause of the
stiff movement or blockage
• Check the encoder cable
and replace, if necessary
• Replace the encoder
If the stepper motor is not
supplied with current:
• Check the stepper motor
cable and replace,
if necessary
• Replace the stepper motor
2103
Error
X-axis stepper motor step
losses:
• Stiff mechanical movement
or blockage
• Remove the cause of the
stiff mechanical movement
or blockage
2121
Error
X-axis stepper motor:
• Encoder plug (Sub-D,
9-pin) not connected or
defective
• Encoder defective
• Check the connection of
the encoder cable and
replace, if necessary
2122
Information
Magnet wheel search
timeout
• Check connection cables
• Check stepper motor for
stiff movement
2130
Error
X-axis stepper motor not res-
ponding
• Perform a software update
• Replace the control
2152
Error
X-axis stepper motor over-
current
• Replace the stepper motor
2153
Error
Excess voltage
• Check the mains voltage
2155
Error
X-axis stepper motor
overload (I²T):
• Stepper motor not moving
freely or blocked
• Stepper motor defective
• Controller defective
• Remove the blockage or
the cause of the stiff
movement
• Replace the stepper motor
• Replace the control
2156
Error
X-axis stepper motor:
• Stepper motor not moving
freely
• Stepper motor defective
• Controller defective
• Correct the cause of not
moving freely
• Replace the stepper motor
• Replace the control
Code
Type
Possible causes
Remedial action
Summary of Contents for 650-10
