Dürkopp Adler 650-10, Operating Instructions Manual

Page: 147 / 176

Troubleshooting
Operating Instructions 650-10 - 03.0 - 08/2016 145
2262 Error Y-axis stepper motor
disturbance (IDMA auto
increment) • Switch the machine off and
on again
2271 Error Watchdog • Switch the machine off and
on again
• Perform a software update
• Contact customer service
2272 Error Stepper motor overvoltage:
• Stepper motor card
defective
• Replace the control
2273 Error Y-axis stepper motor error • Check the connection
• Test stepper motor phases
(R = 2.8
Ω
, high impedance
to PE)
• Replace the encoder
• Replace the stepper motor
• Replace the control
2274 Error Software error • Perform reset
• Perform a software update
• Contact customer service
2275 Error Magnet wheel search • Check the connection
• Test stepper motor phases
(R = 2.8
Ω
, high impedance
to PE)
• Replace the encoder
• Replace the stepper motor
• Replace the control
2277 Error Stepper motor overload (I²T) • Remove the cause of the
stiff movement or blockage
• Replace the stepper motor
• Replace the control
2278 Error Encoder error • Check the connection of
the encoder cable and
replace, if necessary
• Replace the control
2279 Error Current sensor:
• Stepper motor card
defective
• Controller defective
• Replace the control
Code Type Possible causes Remedial action