Dürkopp Adler 567 CLASSIC, Service Manual

Page: 72 / 80

Maintenance work
70 Service manual 567 classic - 01.0 - 10/2015
19.1.3 Setting the hook lubrication
The approved amount of oil for hook lubrication is a factory specification.
Hold a sheet of blotting paper near to the hook when sewing.
Correct setting
After sewing a stretch of approx. 1 m, the blotting paper will have been
sprayed with a thin and even film of oil.
Cover
• Throat plate slide (

3.3.5 Opening and closing the throat plate slide ,
page 13)
Fig. 59: Setting the hook lubrication
Setting steps
1. Turn the screw (3):
• Turn counter-clockwise: more oil is released
• Turn clockwise: less oil is released
The released amount of oil does not change until the operating time has
run a few minutes. Sew for several minutes before you check the setting
again.
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
When holding the blotting paper, make sure that you
do not reach into the hook or underneath the area of
the needle and sewing feet.
Switch off the sewing machine before adjusting the
hook lubrication.
3
2
1
(1) - Hook
(2) - Blotting paper (3) - Screw