21
T C - 1 2 T R E E C H I P P E R
O P E R A T I N G I N S T R U C T I O N S
3.4 Safety bumper bars
The safety bumper bars are located on each side of the infeed. After these bumpers are pressed, the feed forward switch
will not work until the reset button on the engine control panel is pressed. Feed reverse will still work if bumper is
pressed. Feed forward will not function if either bumper bar is not working properly. If feed forward does not work
after pressing reset button consult your dealer.
Safety bar
3.5 Normal Start up procedure
Note:
Do not adjust the engine speed control during start-up. The electronic control Unit (ECU) will
control the engine speed during start-up.
Starting a cold engine
Warning:
If engine is equipped with an intake preheater, DO NOT use starting fluid.
When starting, both emergency stops must be pulled out. Rotor cover must be closed. By pressing the start toggle
switch, the yellow LED rotor cover proximity switch will light. Turn engine key.
1. Disengage any equipment that is driven by the engine.
2. Turn the key switch to the RUN position. Leave the key switch in the RUN position for 20 seconds. (This
allows glow plugs time to heat)
Summary of Contents for TC-12
