DURAG D-R 290, Operating Manual

Page: 120 / 202

7 | Checking / setting parameters with D‑ESI 100
120 D-R 290
Example: Settings for checking / synchronising: Date
and time
Setting path:
Site map > »Device (e.g. D‑R 290 ) > >
Common parameters > Bus in­
formation > Current date/time >
Fig. 7.2: Setting the date/time
The D‑R 290 has an internal clock (in the measuring head). It is necessary that the
clock is correctly set for recording messages in the message logbook and for access
to settings.
A specific desired date/time input can be saved in the device (e.g. the system works in
more than one time zone). After this has been input, the time can however no longer
be synchronised (see above); otherwise the input will be overwritten again by the sys­
tem time!
Parameters Description
Current date/time Standard format:
22.08.2011 13:29:28
Set/correct the time
Left click on "device" in the site map.
Left click on for the desired device in the device list.
Under
Common parameters
in the list field after "
Select group
" set "
Bus in­
formation
".
Left click on the "Edit" symbol in the line for which you wish to change the "Cur­
rent date/time".
Perform direct keyboard input to correct the date and/or time in the "
value
" column,
using the specified format.
Synchronising the time
In order to achieve synchronous time input between the time data for any monitoring
system that may be used and the time data for the message logbook, the device time
can be synchronised with the system time (PC time).
Left click on "device" in the site map.
7.2
Step 1
Step 2
Step 3
Step 4
Step 5
Step 1