GRILLE ASSEMBLY INSTRUCTIONS
• Remove the Rear Grille Mounting Nut from the Motor. Place the Rear Grille onto the
Motor Housing, making sure the three holes of the Rear Grille fit over the three
matching prongs on the Motor Housing. Tighten the Rear Grille Mounting Nut
CLOCKWISE (Fig. 4).
• Push the Fan Blade onto the Motor Shaft, lining up the center of the blade with the D-
shape on the Motor Shaft. Tighten the Blade Knob by turning it COUNTER
CLOCKWISE (Fig. 5).
• Align the front grille and hook the top grille clip onto the rear grille (Fig. 6).
• Raise the built in caps around the front grille, fasten the caps onto rear grille (Fig.7).
• To change the tilt angle of the fan, simply tilt the Motor Assembly to the angle desired.
NOTE: This will only work when fan is fully assembled.
Fig. 5
Fig. 6
Fig. 4
MOUNTING NUT
REAR GRILLE
Fig. 7
HUB INSERT INSTRUCTIONS
• Remove clear cover from the fan
hub by rotating clear cover
CLOCKWISE.
• Select desired hub insert card.
• Place hub insert card inside clear
cover.
• Line up bottom and top notches of
the clear cover with the grille’s hub notches (Fig. 8). Using easy finger grip, gently
press and rotate COUNTER-CLOCKWISE to secure in place (Fig. 9).
CHANGING HUB INSERT CARD
• Remove clear cover from the fan hub by rotating clear cover CLOCKWISE and gently
pulling it away from the fan hub.
• Follow hub insert instructions above.
Fig. 9
Fig. 8
035-02050-000_R0 DFS-211 OM EFS 12/1/03 10:58 AM Page 3
