Page 1
COMFORT COOLER
®
Whole House Fans
TM
CAUTION - SAFETY RULES
WARNING - TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
Before servicing or cleaning unit, switch power
off at service panel and lock service disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Installation Work And Electrical Wiring Must Be
Done By Qualified Person(s) In Accordance With All
Applicable Codes And Standards, Including Fire-rated
Construction.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow
the heating equipment manufacturer’s guideline and
safety standards such as those published by the
National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and local code
authorities.
When cutting or drilling into wall or ceiling, DO NOT
damage electrical wiring and other hidden utilities.
CAUTION - For General Ventilating Only, Do Not
Use To Exhaust Hazardous Or Explosive Materials
And Vapors.
CAUTION - This Unit Has An Unguarded Impeller.
Do Not Use In Locations Readily Accessible To
People Or Animals.
Your whole house fan will operate only on 120 Volt,
A.C., 60 Hz (cycle) current.
Permanent THREE WIRE (grounded) wiring must
be used. DO NOT USE AN EXTENSION CORD.
To avoid risk of electrical shock, fire and other
injuries DISCONNECT MAIN POWER SUPPLY prior
to installation.
This fan is to be mounted in a location where the
entrance of drawn in water (rain) is unlikely.
If shutter is removed for servicing, replace before
normal operation.
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRICAL SHOCK, DO NOT USE THIS FAN WITH
ANY SOLID-STATE FAN SPEED CONTROL DEVICE.
Do not operate this fan in areas where gas or oil
fired equipment are in operation.
Wear safety goggles when drilling, hammering or
cutting materials.
READ AND SAVE THESE INSTRUCTIONS!
INSTALLATION AND OPERATION
IMPORTANT: Carefully read these instructions
before you install or operate your new whole house
fan. Proper installation is important to achieve
maximum cooling efficiency. It is necessary to pro-
vide adequate ventilation to meet minimum exhaust
requirements. This prevents pressure build-up in
the attic which will reduce the fan's efficiency. Refer
to the ventilation work sheet on the back page of
this instruction sheet to determine the exhaust air
requirements.
OWNER’S
MANUAL
Keep for
future reference
TRIANgLE ENgINEERINg Of ARkANSAS, INc.
E-mail: [email protected] • Website: www.trianglefans.com
1101 North Redmond Road • Jacksonville, Arkansas 72076 • (501) 982-7558 • Fax (501) 982-5691 • 1-800-255-9014
INSTALLATION RECORD
Please complete for future use.
Model #
____________________________________________
Serial #
____________________________________________
Purchased from
______________________________________
Date Purchased
____________
Date installed
______________
Revised 5/12
LIMITED
10 YEAR
WARRANTY
