81
2
1
Appendix - DC545 HC/DC545 HCEX
3. Range within which the Register Mark can be Adjusted
The DC-545 compensates the position for cutting, creasing and slitting if the register mark discrepancies are within
ranges such that the mark 1 value is +/- 40 (+/- 6 mm), for mark 1 (left/right) in the registered JOB data, and such that
mark 2 (up/down) is between 5 mm and 35 mm from the leading edge of the paper (see the following diagram) regard-
less of the registered job data.
However, even if the register mark is within the range described above, compensation cannot be done for the register
mark if it is outside the range where the printer can print.
Specifications
5mm
35mm
Position of the upper limit that mark 2 of
the register mark can be read
Position of the lower limit that mark 2 of
the register mark can be read
Docu Cutter(HCEX) 6_70-84
03.12.8, 3:12 PM
81
