28
Tip
CCD Scan Mode
How to Change the Settings in the DC-545 CCD
Scan Mode
Where to make the settings
1. Press the “MODE” key and select “BARCODE”.
2. Press the “SET” key.
Switch the display from “BARCODE”
➔
“REGISTER MARK”
➔
“AUTO CUT”
➔
“CCD SCAN. MODE”
3. “CCD SCAN. MODE” appears on the display.
Change the setting (*) with the +, and - keys.
The standard setting for CCD SCAN. MODE is
FAST.
The following conditions might cause the E4 REG MARK ERROR.
q
The roughness of the paper may cause the mark to be unreadable.
w
The REG MARK may not be sharp enough.
e
The paper may be dirty.
If this is the case, switch the setting from FAST to SLOW.
Note:
Even if you switch the setting to SLOW, the conditions noted in
q
,
w
, and
e
may cause the
E4 REG MARK ERROR. If this happens, do the operation without using the REG MARK.
Automatic Cutting Using Bar Codes and Register Marks
CCD SCAN. MODE
* FAST SLOW
Docu Cutter(HCEX) 3_26-29
03.12.8, 3:09 PM
28
