Dunham-Bush ACDS, Installation, Operation & Maintanance Manual

Page: 42 / 93

- 42 -
Technician Setpoints
Main Menu
Comp FLA Calibration ■
Sensor Calibration
Manual Control
Compressor Control
Sensors Override
Technician Setpoint 1
Comp 1 FLA CALIBRATION
211x00.66+97.80
FLA = 237A
Capacity C1 = 000.0%
Min. Percent Cal = 25.0%
Max. Percent Cal = 00A
Technician Setpoints
Main Menu
Comp FLA Calibration
Sensor Calibration
■
Manual Control
Compressor Control
Sensors Override
Sensor Offset 1
Suction Press
Current = 076PSI [5.4BAR]
Average = 187PSI [8.6BAR]
24Hrs MAX = 200PSI [11.4BAR]
24Hrs MIN = 074PSI [4.6BAR]
Calibration = 00PSI [0.0BAR]
Technician Setpoints
Main Menu
Comp FLA Calibration
Sensor Calibration
Manual Control ■
Compressor Control
Sensors Override
4.0 ELECTRICAL
The display is showing the data as
follows:
4.3.5.3 Compressor FLA Calibration:
To calibrate compressor FLA, press
down arrow key to go the sub-menu
'Comp FLA Calibration',
The display is showing the data as
follows:
Press enter key to move the cursor to
calibrate the comp FLA and use the up-
down arrow key to change the value
and press enter key to confirm.
4.3.5.4 To perform Sensor Calibration:
Press technician key to go to technician
setpoints main menu and press enter
key twice to move the cursor to the
sensor calibration sub-menu:
The display is showing the data as
follows:
Use up or down arrow key to move the
cursor to the desired 'Sensor
Calibration',
The display is showing the data as
follows:
Press enter key to move the cursor to
calibrate the desired sensor and use
the up-down arrow key to change the
value and press enter key to confirm.
Repeat the above steps for others
sensors calibrations.
4.3.5.5 Manual Control:
A digital input sensor or relay output
can be controlled manually with the
keypad. Digital input sensor or relay
output can be turned on, off manually
and placed back to auto mode.
To place a digital input or relay output
in manual control, the operator must be
authorized at technician level or higher.
Press technician key to go to technician
setpoints main menu and press enter
key three times to move the cursor to
the manual control sub-menu:
The display is showing the data as
follows: