MAINTENANCE OF YOUR
WEIGHT & TRIM SYSTEM
Proper maintenance of your Weight & Trim System is very important. It is very
simple to care for and requires a minimum amount of attention.
POST DIVE CARE
• Rinse the entire system thoroughly with fresh water.
• Remove the weights from the pockets and flush the pockets with fresh
water.This will remove any sand or other matter that may have accumulated
in the pockets.
• Do not dry in direct sunlight.
• Store in a cool dry place.
REATTACHING WEIGHT POCKETS OF THE WEIGHT
& TRIM CLASSIC
If you have released the weights you will need to restring them before you can
use the Weight & Trim Classic for diving again.This is a very simple procedure
that can be accomplished in a few minutes.There is a left and right weight
pocket assemby. They are not interchangeable.
To install the weight pockets perform these steps:
1. Attach the patch of pile fastener on the weight release handle to the patch
of hook fastener on the back of the weight
pocket assembly.
2. Thread the nylon lanyard that attaches
the weight release handle to the
weight pocket assembly under the
nylon loop on the back of the
weight pocket assembly so that it
lies flat.The lanyard will be doubled
over when it is properly installed. See
Figure 6.
3. Place the back side of the weight pocket assembly against the outside of
the weight carrier so the mounting webbing loops on the weight pocket
assembly line up with the grommet holes on the weight carrier. If the
holes do not line up exactly, either it is on upside down, or you have the
18
Maintenance.........................................
Figure 6
Summary of Contents for Weight & Trim Classic
Page 1: ......
Page 25: ...24 Notes ...
