INSPECTING THE WEIGHT & TRIM SYSTEM PRIOR
TO USE
Always take the time to carefully inspect your Weight & Trim System prior to
each dive. Inspect the following items:
1. Test the weight release mechanism on each side for proper operation.
They should not be worn or broken.
2. Inspect the mounting loops on the back of each weight pocket assembly.
All six pocket mounting loops should be securely attached and in good
condition.
3. Inspect the waist belt buckle and shoulder strap slides.They should
function properly and not be cracked or broken.
4. Inspect and test the hook and pile fastener on the pocket flaps and weight
release mechanism. If there is insufficient adhesion between the mating
surfaces they must be replaced.
!! WARNING !!
Hook and pile fasteners have a limited useful number of
cycles. When it no longer has the same holding power it
did when it was new it must be replaced.
PUTTING ON THE WEIGHT & TRIM SYSTEM
• To put on the Weight & Trim System by yourself, first check to be sure that
all of the weight pockets are properly closed. If the pockets are not closed
correctly, weights could fall out of the pocket and possibly damage your
equipment or injure other divers around you.The buckle at the waist must
be open.
!! WARNING !!
Always check to ensure that all of the weight pockets
are securely closed before putting on the Weight & Trim
System. Any weights that fall out of the pockets may
cause personal injury, damage your equipment
or injure others.
12
Preparation...........................................
Summary of Contents for Weight & Trim Classic
Page 1: ......
Page 25: ...24 Notes ...
