Dualit 85172, Instruction Manual & Guarantee

Page: 7 / 21

12 13
SETTING UP
- CONTINUED
1
Remove Internal Drip
Tray by pulling on the
handle.
Check that the
Grounds Container is in
place.
2 3
Install the Internal Drip Tray
into the machine. The front
of the Drip Tray must be
flush with the machine, if it
is not, there is likely to be an
obstruction.
Press on the bottom of the
Service Door to raise its
top edge. Pull on the top
edge to remove the Service
Door.
Remove the Infuser by
pressing both the orange
buttons inwards.
Note: The Warning
Light will turn on when the
infuser is removed.
4
REMOVE INFUSER
CHECK GROUNDS
CONTAINER
REMOVE SERVICE
DOOR INTERNAL DRIP
TRAY INSTALL
Push the Infuser into the Infuser
Support. Ensure that both
of the orange clips engage.
There will be an audible click
once engaged correctly. The
Warning Light will show if
the Infuser is installed incorrectly.
7
Align the Service Door’s two
metal pins into the slots of
the appliance body. Once
aligned, push the Service
Door into place.
9
Ensure the External Drip
Tray Cover is placed into
the External Drip Tray. Push
the External Drip Tray into
the cut-out at the front of
the machine. The tray will
secure itself with magnets.
Position in a safe space. This
must be away from heat
sources, water taps and not
in a cupboard. The surface
must be flat in order to
keep the machine level and
stable.
Lift out the Water Tank using
the Handle. Rinse before filling
with fresh water. DO NOT
USE ANY OTHER LIQUID
Maximum fill level is the
MAX Marker. Do not
overfill.
10
REMOVE AND FILL
WATER TANK
SERVICE DOOR
INSTALL
POSITION
Rinse Infuser with warm
water and dry afterwards.
DO NOT PLACE IN
DISHWASHER.
5
RINSE INFUSER
U
N
PL
U
G W
HEN NO
T
IN
U
SE
SW
ITCH OFF &
8
EXTERNAL DRIP
TRAY
6 INFUSER INSTALL
SETTING UP
Ensure that your machine is unplugged and cool before starting. Remove all packaging and
protective films from the Appliance, including the protective cover on the Control Panel, then
follow the next steps to ensure your machine is set up correctly. This process will help you
achieve optimum performance and will take approximately 15 minutes to complete. Note: The
Control Panel will not work with the protective cover in place.
IMPORTANT NOTICE:
PRODUCT FAILURE
DUE TO THE BUILD
UP OF LIMESCALE
IS NOT COVERED BY
GUARANTEE.
Dualit
recommends descaling regularly,
in a well-ventilated area, to
prevent limescale build-up in the
machine. See Limescale Warning
on page 8 for frequency in your
area in accordance with the
hardness of your water. Dualit
recommends the use of an
OSCAR Water Softener Bag in
all areas. See page 8 for further
guidance. For more information,
visit our website dualit.com/
products/machine-care or
contact our Customer Services
on 01293 652500
Register your product at
dualit.com . This will only
take 60 seconds. You will
need the product model
and serial number that are
on the rating label on the
base of the product.
DON’T FORGET
TO
REGISTER
YOUR PRODUCT
WWW.DUALIT.COM/REGISTER
OR BY POST