DTM System PIKO, User Manual, Page: 14 / 16

2.7. Deleting a single remote control from the receiver's memory
To remove a single remote from the receiver's memory, hold down the receiver button and press the active remote control
button.
Holding down the receiver button for more than 15 seconds will remove all the remote controls from the receiver.
2.8. Memory format
To format the receiver's memory, press and hold the receiver button for 15 seconds. Release the button only when the light goes
out.
Memory format:
ź
removers all remote controls from the receiver,
ź
disables the easy remote adding lock,
ź
deletes the Galactic authentication code from the receiver.
2.9. Verifying number of added remotes
To verify number of registered remotes, prior registering or removing remote is required.
After registering or removing remote, hold receiver button for 5 more seconds. LED will blink showing number of registered
remotes. First number of tens (from 0 to 20 long pulses), then number of units (from 0 to 9 short pulses). In the PIKO version, the
indicator lamp flashes indicating the number of programmed remote controls.
Fig. 8 . Pulses example, showing 46 registered remotes.
number of tens - 4x10
number of units - 6
1 2
AFTER 15 SECONDS
C1 LED GOES OUT
- FORMAT SUCCESSFUL
> 15s
Fig. 7. Memory format.
PRESS AND HOLD C1
LED PULSES
2 3 1
PRESS AND HOLD C1
LED PULSES
PRESS REMOTE
ACTIVE BUTTON C1 LED GOES OUT
- DELETING SUCCESSFUL
Fig. 6. Deleting a single remote control.
PL
EN