DTM System PIKO, User Manual, Page: 11 / 16

GENERAL INFORMATION
The series of 1-channel PIKO receivers are designed for cooperation with gate controllers, roller shutters and other automation
devices, where the remote control is required. It allows to easily extend the functionality of the installation with the remote
control function.
TECHNICAL DATA
1. Installing the receiver
The receiver is intended for use inside
installation boxes, inside buildings and inside
enclosures of other automation devices, while
ensuring appropriate operating conditions,
consistent with the device parameters. Do not
install the receiver in places subject to high
humidity or frequent and sudden changes in
temperature.
Othe receiver has a cable harness with four wires
(fig.1) for connecting the receiver's power supply
- red and blue, and for connecting a controlled
device - white and black. The receiver is factory
equipped with a wire antenna.
The housing has a hole for a clamp for
convenient mounting of the receiver.
Pay attention to the colors of the
w i r e s a n d c o n n e c t t h e m a s
intended!
AVAILABLE FUNCTIONS
12-24V
C NO
WHITE BLA
CK
RED BL
UE
C1 programming
button
C1 LED
cable
harness
antenna
+~_
12…24V AC/DC ±10%
30mA
1A/24V AC/DC
-20°C /+55°C
41x30x19 mm
IP-20
433MHz 868MHz
40mA
15 remotes
DTM433MHz
+ other
producers
150 remotes
DTM433MHz
150 remotes
DTM433MHz
+ other
producers
200 remotes
DTM868MHz
15 remotes
DTM433MHz
MEMORY
FREQUENCY
POWER SUPPLY
POWER CONSUMPTION
OUTPUT
OUTPUT LOAD
OPERATION MODE
TEMPERATURE
INGRESS PROTECTION
DIMENSIONS
one, separated NO type
monostable, turn-on time 1s
EASY REMOTE ADDING
EASY REMOTE ADDING LOCK
GALACTIC FUNCTION
VERIFYING NUMBER OF REMOTES
only DTM433MHz only DTM433MHz
Fig. 1. View of the receiver
with pin description.
EN