Version 4/5/6/7
DTDAUTO VIETNAM Co., Ltd – EDITED 29/10/2020
www.dtdauto.com
65
You use “
MT0006 – LINK
” cable to connect between
MOTOBOX
and
MOTOSCAN
as below:
After you have completed this connection, please press “
Select/ OK
”
button to continue.
IMPORTANT NOTES:
When you simulate ignition signal or CKP signal on motorcycle, you must
remove the spark plug out of engine to have not ignition in the
combustion chamber; incorrect ignition timing can cause mechanical
troubles on motorcycles…
If MOTOSCAN don’t communicate with MOTOBOX or “MT0006-LINK” cable
is faulty or communicating between MOTOSCAN and MOTOBOX has been
lost synchronization then the screen displays as below:
Step 3:
The screen displays simulation signals. Press “
Shift Up/ Down
”
button
to view list of signals, you select signal type that you need simulate
then press “
Select/ OK
” button.
Example:
CKP signal:
Version 4/5/6/7
DTDAUTO VIETNAM Co., Ltd – EDITED 29/10/2020
www.dtdauto.com
66
Step 4:
Use “
4
” or “
6
” button to increase or decrease value of electric pulse signal.
Use knob on MOTOBOX to adjust voltage value of signal.
Example: Decrease or increase engine speed
Step 5:
Use the simulation signals to generate at output of MOTOBOX for
diagnosis and ECU repair. You view below image:
IMPORTANT NOTE:
Signals able to operate independently even when still supply power for
MOTOBOX and then disconnect “ET0006 - LINK” cable with MOTOSCAN,
this time technicians can use MOTOSCAN for other purposes.
GND
IGPLS, INJ
(20VDC/20A)
CKP, VSS
(12VDC/0,1A)
MAP, TP, TW, TA
(0.2÷5VDC/0,5A)
