Version 4/5/6/7
DTDAUTO VIETNAM Co., Ltd – EDITED 29/10/2020
www.dtdauto.com
3
1.2 FUNCTIONS
FUNCTION 1: DETERMINE FAULT
1. Read, clear fault codes stored in ECUs of engine system and ABS
system
2. Find complex faults that MIL lamp does not indicate such as:
- Diagnose faults by the automatic data analyzing and interviewing the
technicians
+ Can’t start engine
+ Down power when accelerate
+ Idling stop fault
+ Fuel consumption
+ Starter is not work
+ Random acceleration
+ Constant acceleration
+ Idling not work
+ Hard to start engine
+ Weak engine
+ Injector mechanical fault
- Diagnose faults by analyzing the engine live data and activate the
actuators
+ Voltage and open angle of throttle position sensor (TPS)
+ Voltage and value of intake air temperature sensor (IAT)
+ Voltage and value of manifold air pressure sensor (MAP)
Version 4/5/6/7
DTDAUTO VIETNAM Co., Ltd – EDITED 29/10/2020
www.dtdauto.com
4
+ Voltage and value of engine temperature sensor (ECT)
+ Voltage and value of oxygen sensor (O2S)
+ Value of atmospheric pressure sensor
+ Engine speed (CKP/ NE)
+ Vehicle speed (VSS)
+ Front/rear wheel speed (with ABS system)
+ Status of fuel pump
+ Ignition timing advance (ISA)
+ Fuel injection time (Ti)
+ Starter signal (STP)
+ Status signal of side stand switch (SSTAND-SW)
+ Status Hall sensor
+ Evaporative purge cut solenoid valve output signal (PCS)
+ Output signal active starter relay (ON/OFF)
+ Output signal active PCV
+ Output signal active IACV
+ Output signal active MIL
+ SCS input signal status (service check signal)
+ Open state of step motor (IACV)
+ State of heater of O2 sensor
+ State of brake switch
+ State of Start & Stop indicate lamp
+ State of Star t& Stop mode button
+ State of start button
+ State of pre-positioning
+ Status of direction sensor
+ Status of oil minimum pressure sensor
+ Engine stop command from DSP
+ Battery voltage (BATT)
+ Battery current
+ Short term fuel trim in closed loop
+ Environmental revision coefficient in closed loop
+ Fault code and total fault codes
+ And other parameters vv...
-
Activate and reset the actuators:
Fuel pump, injector, ignition coil,
IACV (ISCV), O2 heater, pump, blower, head lamp, MIL warning lamp, ABS
warning lamp, Immobilizer lamp, Start&Stop lamp, engine oil pressure
warning lamp, VVA valve, reset pre-positioning of crankshaft ...
FUNCTION 2: REPAIR FAULT
1. Automatically program smart key for HONDA, YAMAHA, SUZUKI:
- Read all KEYID# and ECMID from vehicle SCU
- Program smart key directly with vehicle or without vehicle (SCU is not
installed on vehicle) for cases:
+ Register more FOB# for all of cases
+ Register FOB# when lost all of the FOB#
+ Delete KEYID in SCU memory
