■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
▼
Installing the Hardware
DS1104 Hardware Installation and Configuration March 2004
29
▲
■■■■■■■■■■
I
▲
■
■■■■■■■■■■■■■■
How to Connect a Panel (CP, CLP) to a
Board
For safe and trouble-free operation of the panels, various guidelines
must be observed. For details, refer to
Safety Precautions for Using
Connector Panels
on page 19.
Precondition
The system is switched off.
Method
To connect a panel to the DS1104
C
CAUTION! Connecting external devices while the power supply
is switched on may damage the dSPACE hardware.
■
Do not connect or disconnect any device while the power supply is
switched on.
■
Turn off the host PC and the external devices beforehand.
1
If the panel is to be mounted in a 19” rack, this should be done
first (see
How to Mount a Panel in a 19'' Rack
on page 30).
2
Plug the CP1104 or CLP1104 to the DS1104 and tighten the lock
screws. Take care not to mix up the connectors of the DS1104.
Connectors are installed correctly when ribbon cables are not
twisted and do not cross over each other. Furthermore, the
connectors are marked by labels P1A, P1B, etc.
3
Put templates on the panel. Turn the black clips on the panel
through 90 degrees to secure the templates to the panel.
4
Now you can connect devices to the panel. For detailed
instructions, refer to
How to Connect External Devices to a
Connector Panel
on page 74.
Next step
Now you can switch on the dSPACE system.
Summary of Contents for CLP1104
Page 6: ...Contents DS1104 Hardware Installation and Configuration March 2004 I 6 ...
Page 20: ...Safety Precautions DS1104 Hardware Installation and Configuration March 2004 I 20 ...
Page 118: ...Mapping of I O Signals DS1104 Hardware Installation and Configuration March 2004 I 118 ...
Page 162: ...Data Sheets DS1104 Hardware Installation and Configuration March 2004 I 162 ...