■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
▼
Signal Connection to External Devices
DS1104 Hardware Installation and Configuration March 2004
131
▲
■■■■■■■■■■
I
▲
■
■■■■■■■■■■■■■■
Encoder power
supply lines
The DS1104 offers a 5 V supply voltage for the incremental encoders.
These voltage outputs (
VCC
) are connected to the PC‘s 5 V power
supply via a multifuse.
If a supply output is overloaded or shorted, the multifuse is heated by
the overcurrent and abruptly increases its resistance. To reset the
multifuse to its initial low resistance, remove the power for some
minutes to allow the multifuse to cool down.
You should use the
VCC
supply voltages for all connected incremental
sensors.
Summary of Contents for CLP1104
Page 6: ...Contents DS1104 Hardware Installation and Configuration March 2004 I 6 ...
Page 20: ...Safety Precautions DS1104 Hardware Installation and Configuration March 2004 I 20 ...
Page 118: ...Mapping of I O Signals DS1104 Hardware Installation and Configuration March 2004 I 118 ...
Page 162: ...Data Sheets DS1104 Hardware Installation and Configuration March 2004 I 162 ...
