19
[007] DNS Server IP 1
Default (000.000.000.000)
i
Programming this Section is
not
permitted on a UL/ULC listed system.
Enter the IP address for DNS Server 1. Format is 4 fields, each field is a 3 digit
decimal. Valid range: 000-255.
NOTE: If no value is programmed and DHCP is used, the DHCP Server will configure
the address. If an address is programmed and DHCP is used, the address that you
program will be used instead of the DHCP address.
[008] DNS Server IP 2
i
Programming this Section is
not
permitted on a UL/ULC listed system.
Default (000.000.000.000)
Enter the IP address for DNS Server 2. Format is 4 fields, each field is a 3 digit
decimal. Valid range: 000-255.
NOTE: If no value is programmed and DHCP is used, the DHCP Server will assign this
value. If an address is programmed and DHCP is used, the address that you program
will be used instead of the DHCP address.
P
ROGRAMMING
O
PTIONS
[010] System Toggle Option
Default (Disable)
[1] This bit is used to enable/disable two way audio over 3G.
[011] Installer Code
Default (CAFE)
Program your installer code for this Communicator module. The installer code will be
required when programming the Communicator module. Valid range: 0000 - FFFF.
[012] DLS Incoming Port
Default (0BF6/3062)
The DLS Incoming Local Port (listening port) is the port DLS IV will use when con-
necting to the Communicator. If a router or gateway is used, it must be programmed
with a Transmission Control Protocol (TCP) port forward for this port to the Communi-
cator module IP address. Valid range: 0000 - FFFF.
[013] DLS Outgoing Port
Default (0BFA/3066)
The DLS Outgoing Port is used for outgoing session to DLS IV after an SMS request
has been sent to the Communicator. Use this Section to set the value of the local out-
going port. The value must be changed if the Communicator is located behind a fire-
wall and must be assigned a particular port number, as determined by your network
administrator. In most cases, changing the default value or configuring your firewall
with this port is not required.
Valid range: 0000-FFFF.
NOTE: If Section [006] Toggle Option [7] is ON, DLS will use the Primary path for
session. If Section [006] Toggle Option [7] is OFF DLS will use the Ethernet
path, if available.
[020] Time Zone
Default (00)
Use Column 2 (Offset Hours) to find your local Time Zone. Record the two digit HEX
value from Column 1 (HEX Value) on the same row. Program this HEX value for your
Time Zone. Valid range is 00 - FF.