Ignis Operations Manual
Drone Amplified
Snap the Hopper onto the rails of the drone, as shown in Figure 4.1.10 (left/right), and slide
it along the rails to ensure that the Hopper is aligned with the center mass of the drone.
Finally, reinstall and lightly tighten the red thumb screws to secure the Hopper to the drone.
Note that the Hopper should be oriented such that the reservoir is towards the back of
the drone.
4.1.11 Connect Ignis USB Cable
Connect to Drone:
CONNECTED
Figure 4.1.11: Top Left: Attaching cable to M600. Top Right: Attaching cable to Alta X.
Bottom: Attaching cable to IF 1200.
Attach the cable between the hopper and the drone as shown in Figure 4.1.11.
Last Updated
Page 37
Apr 13, 2022
