Ignis Operations Manual
Drone Amplified
Clamp the USB port attachment to the upper rail under battery bay 6 by unscrewing the
four screws holding the tube clamps together, sliding the usb attachment into the proper
place, and then screwing the tube clamps back together.
Figure 9.2f: Ziptie the connectors in place.
Next, ziptie the connectors in place as shown in Figure 9.2f. When doing so, we
recommend first mounting the Ignis system to ensure that the connectors are in accessible
locations. Make sure not to pinch the wires too tight with the zipties. The connectors to the
Ignis should be on the front of the Matrice 600 between battery bays 1 and 6. We
recommend securing the extra PWM connectors at the rear of the vehicle between battery
bays 4 and 5.
Finally, put the top and bottom covers back on the Matrice 600. Pay special attention to
not pinch any wires when replacing the covers. In particular, the new Ignis communication
wires should be routed through existing openings in the bottom case.
9.3 DJI Software Configuration
Download and install DJI Assistant 2 (which is required to activate the DJI Matrice 600
before the first flight). Connect the vehicle to your computer using a USB cable, and turn it
on. Then select the Matrice 600 in the “Connected Devices” screen of DJI Assistant 2.
Last Updated
Page 166
Apr 13, 2022
