IDSOFT IFU (Iss 09/15)
Page 2
When using the wheelchair alone, the user should
ensure the backrest is in its most upright position for
maximum stability.
Prohibited Use
The wheelchair is suitable for a single occupant only
and is not suitable for carrying heavy goods. Do not use
the wheelchair if it is not in a good condition.
The legrests should always be used with the wheelchair.
Environment
Before use, the operating environment of the
wheelchair should be considered. Always check door
widths and thresholds are compatible for the
wheelchair. Pay attention to nearby stairs and objects
protruding from walls which could present a hazard to
the user.
3.
Parts Description
4.
Safety and Transportation Instructions
Carrying and Lifting
Under no circumstances should the wheelchair be lifted
whilst the user is occupying the chair. The wheelchair
user should exit the wheelchair and the wheelchair can
be lifted using the frame. Do not lift by the legrests,
armrests or other components on the wheelchair.
Using the Wheelchair as a Seat in a Motor Vehicle
Drive Medical
recommends that when in transport a
wheelchair user should whenever possible transfer to a
vehicle seat and be restrained using the vehicle
provided occupant restraint system. However, there are
circumstances and situations where such a transfer may
not be possible and that the IDSoft Wheelchair can be
used as a seat within a vehicle.
In preparation for use as a seat in a vehicle, Drive
Medical
has subjected the wheelchair to the dynamic
test requirements of ISO 7176 Part 19:2008 and
satisfied all performance requirements.
Drive Medical recommends that the IDSoft Wheelchair
should be used forward facing in the vehicle, be secured
using a 4 point tie-down system and a 3 point occupant
restraint used to restrain the wheelchair user.
The backrest on the wheelchair should be in the upright
position and the leg rests should be lowered.
A four point wheelchair tie-down and occupant
restraint systems in compliance with ISO 10542-1:2012
would be suitable. The wheelchair was successfully
dynamically tested using an Unwin system.
The wheelchair occupant should sit as upright as
possible when in transport, ensuring that the lap belt
lays as low as possible on the pelvis to avoid harmful
loading of the abdomen, and that the upper section lay
midway on the shoulder of the passenger.
Posture Support Devices such as a pelvic belt or an H-
Type harness should not be relied on as a restraint
system when in transport.
In situations where significant deviations from an
upright seated posture are presented or the addition of
other medical devices are required, a full risk
