IDSOFT IFU (Iss 09/15)
Page 10
Installation of Trunk Support (Optional)
Assembling:
Slightly unscrew the screws (
A
), position
the clamp onto the backrest support, adjust the
height, and then retighten the screws (
A
).
Height adjustment:
After adjusting the backrest to the desired height,
adjust the trunk-support height using the screws
(
A
), and then securely tighten them (
5-mm hexagonal
key
). It is possible to complete the height-
adjustment by changing the pad position on its
support. To this end, unscrew both screws (
E
),
move the pad on (
F
), and then securely retighten
both screws.
Depth adjustment:
Use knob
B
to adjust the trunk-support depth. If
necessary, use the knob (
D
) to tune the adjustment
(knob
D
is located under the trunk-support cover.
Pull the fastening to access it).
Angle adjustment and retraction:
Pull the pad upwards (
G
) giving it the desired angle.
Release the pad.
Depth adjustment:
Use knob
B
to adjust the trunk-support depth. If
necessary, use the knob (
D
) to tune the adjustment
(knob
D
is located under the trunk-support cover. Pull
the fastening to access it).
Installation of the Tray (Optional)
Support Assembly
The supports are already assembled
when the tray is purchased with the wheelchair. If the
tray purchased separately then follow the procedure
below.
Unscrew the 3 screws ( C) and insert the tray support
(D) in between the armpad (F) and the support (G).
Tray Assembly
(Movement 1)
After slightly unscrewing
H
and
separating the rods
I
and
Y
engage and slide I into the
tray grooves until the end.
(
Movement 2)
Engage the rod
Y
and
I
, and then slide in
to tray grooves (
Movement 3)
Adjust the spacing between I and Y so that they fit in to
the tray supports mounted on the wheelchair and the
tray sits centrally in the wheelchair.
G
B
A
D
G
F
C
