IDSOFT IFU (Iss 09/15)
Page 9
Installing the Backrest and Seat Pads
The seat and backrest pads of the seat are attached
with hook-and-loop tape. Pull the pad away from the
base to remove. To install the pads, simply place them
in the required position and push against the pad so
that the hoop-and-loop tape secures the pads.
Third Party Seating Systems
The seating on the ID Soft can be fully removed and a
third-party seating system installed.
Caution: Installing a third-party seating system
may affect the product performance and
safety of the product, in particular to the
performance of the wheelchair as a seat in a
motor vehicle. A full risk analysis should be
conducted before a third-party system is
installed. Drive Medical accepts no
responsibility for damage or injury as a result
of a third-party accessory being installed.
Seat Depth Adjustment
Slightly unscrew the 4 screws (
D
) of the seating plate,
position the seat to desired depth (between 0 and + 50
mm). Retighten the 4 screws.
Seat Width Adjustment
Slightly unscrew the both screws (C) on the underside of
the seat. Move the supports inwards or outwards until
the desired width is reached and then retighten the
screws.
Installation of Abduction Wedge (Optional)
Remove both
B
caps at the front of the seat.
Mount the assembly as shown in the diagram.
To adjust the wedge depth, unscrew the thumb
wheel (
A
), position the wedge through sliding it, and
then retighten the thumb wheel (
A
).
A
B
