www.petsafe.net 9
8
www.petsafe.net
EN
ES
FR
IT
NL
DE
.
9. Detach the lid from the base of the Filter Housing.
Once rinsed off, place the Charcoal Filter inside
the base of the Filter Housing with the larger side of
the filter facing down. The filter will only fit inside
the base of the Filter Housing one way. If it does
not fit, flip it over (
Fig. 7
).
10. Attach the lid to the base of the Filter Housing.
Press down until you hear it snap in place.
11. Attach the Filter Housing to the Pump by inserting
the round notch under the base into the circular
opening on top of the Pump (
Fig. 8
). The opening
on top of the Filter Housing should be right next to
the sealed raised post (
Fig. 9
).
12. Place the ceramic Tower inside the Bowl. The
Rubber Grommet will create a seal between the
Filter Housing and the Tower. Carefully lower the
Tower until it rests flat (
Fig. 10
).
Set Up and Add Water
1. Place the Pet Fountain in desired location. Do not pick up a full fountain by the Tower
piece. To properly pick up the Pet Fountain, use both hands and grip the sidewalls of
the Bowl and lift up.
2. Fill the Pet Fountain by pouring water directly into the Bowl. Leave at least 1.27 cm
of space between the water level and the rim of the Bowl to help control spills and
splashing. To protect your floor always use a protective mat, such as a towel or
water resistant placemat. This will help protect your floor from splashing or spills
caused by your pet.
3. Before you plug in the Pet Fountain, make sure the electrical power cord, the adaptor
and your hands are completely dry. Connect the in-line plug and make sure no silver
is showing, then plug the adaptor into a wall outlet.
4. Add water to the Bowl as needed. Never let the water level fall below 2.54 cm from
the base of the Bowl or you might risk Pump failure. Replacement Pumps are sold
separately by contacting the Customer Care Centre.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
