www.petsafe.net 11
10 www.petsafe.net
EN
ES
FR
IT
NL
DE
.
4. Remove the Filter Housing from the Pump by lifting
straight up (
Fig. 14
).
5. Open the Filter Housing and remove the Charcoal
Filter from inside and dispose. Set the lid and base
of the Filter Housing aside for cleaning.
6. Remove the Rubber Cap affixed to the raised post
by inserting a finger under the lip and pull straight
up to remove (
Fig. 15
).
7. While securely holding the electrical power cord
and the bottom of the Bowl with both hands, pour
out the remaining water inside the Bowl into a sink.
8. With the in-line plug disconnected and water
removed, grab the Pump and lift straight up to
disengage the suction cups. Continue pulling
the Pump’s electrical power cord up and out
through the raised post in the center of the Bowl.
Once the Pump is completely removed from the
Bowl, separate the Foam Filter and set aside for
proper cleaning.
9. Once the Pet Fountain is completely disassembled,
you will have: the Bowl, Tower, two rubber pieces, the Filter Housing, Foam Filter
and the Pump.
10. Rinse the Foam Filter with water only or replace it with a new one.
11. See the “Pump Maintenance” section of this Operating Guide for detailed
instructions on how to properly clean your Pump.
DO NOT PLACE PUMP IN
DISHWASHER!
12. Hand wash all other fountain parts with warm water and soap. Be sure to rinse
thoroughly with fresh water. You can also put the Pet Fountain in the top rack of the
dishwasher. If possible, it is recommended that you turn down the heat of the water
inside the dishwasher.
13. If you have trouble reaching certain spots or hard-to-reach areas, try using a cotton
swab or purchase the Drinkwell
®
Cleaning Kit, a 3-Piece Brush Kit. To purchase a
Cleaning Kit, visit our website at www.petsafe.net to locate a retailer near you or
contact the Customer Care Centre.
Fig. 14
Fig. 15
