24
Observe all provided
warnings and safety
instructions when using the Dremel LC40
Laser Cutter.
Failure to do so may result in
fire, equipment damage, property damage
and/or personal injury, up to and including
death.
Always use a properly
configured, installed,
maintained, and operating fume/smoke
exhaust system as recommended by the
manufacturer when operating the laser
cutter.
Caustic fumes and smoke from the
cutting and engraving process must be
extracted from the laser system and
exhausted outside or properly filtered to
reduce the risk of personal injury.
Discontinue use and
seek
fresh
air
if
respiratory or eye irritation occurs.
Ensure ventilation, exhaust, and/or
filtration systems are working according
to manufacturer specifications and make
any necessary adjustments before further
use.
Exposure to fumes may cause allergy,
asthma, breathing difficulties or other
adverse health effects.
Comply with all codes,
regulations and laws,
including those for hazardous or noxious
exhaust ventilation systems. Consult with
federal, state and/or local authorities and
applicable homeowner or condominium
associations to ensure compliance of
ventilation and exhaust systems.
Failure
to do so may result in fire, equipment
damage, property damage and/or personal
injury, up to and including death.
Consult a qualified
installer or service
agency for information or assistance if
installation of exhaust/venting is beyond
your skill level.
Improper installation,
adjustment,
alteration,
service,
maintenance, or use can cause fire, electric
shock or other conditions which may cause
personal injury, property damage or even
death.
Always use fire rated
rigid or flexible metal or
metalized ducting in the exhaust system.
Non-fire rated exhaust ducting may
increase the risk of fire.
Maintain
all
m a n u f a c t u r e r
recommended clearances during exhaust
installation.
Failure to maintain proper
clearances could result in personal injury,
death and/or property damage.
Wear proper personal
protective equipment
such as safety glasses, protective clothing
and work gloves when performing
exhaust connections.
Failure to do so may
result in personal injury.
Proper ventilation and/or filtration of the
Dremel LC40 Laser Cutter’s exhaust is
mandatory. During operation, the Dremel
LC40 Laser Cutter melts and/or burns
material and may generate fumes and/or
smoke that may be hazardous to health. An
effective ventilation and/or filtration
system is necessary to remove these
products. Always ensure the selected
exhaust management method is operating
before starting a job, and let it run for at
least 10 minutes after the job is finished to
evacuate exhaust out of the Dremel LC40
Laser Cutter. Wait at least 30 seconds
after the job is finished before lifting the
glass Lid.
SETUP
Exhaust Management
DM 1600A01CX8 08-18 LC40 EN.qxp_LC40 8/17/18 10:32 AM Page 24
