8.
Arrange servos on table and attach a servo arm to
each servo.
IMPORTANT: Servo arms must be
installed in the orientations shown to ensure
proper control function.
9.
Referring to graphic to the right, check for correct
servo rotation direction. If needed, reverse servo
directions using transmitter. If you cannot achieve
the correct rotations using servo reversing alone,
you may need to swap the servo plugs at the
receiver and return to Step 8 above.
10.
If necessary, adjust sub-trims to ensure servo arms
are at 90 degrees as shown.
11.
With a bit of masking tape, label each servo for
future reference during installation (i.e. Right, Left).
12.
Re-install two tiny screws to secure each servo arm.
13.
Power down receiver by unplugging battery from
Battery Extension Wire. Now turn off transmitter.
4.
