FUSELAGE PREPARATION
Gather items below:
Fuselage with canopy
(2) Elevon servos
Receiver with Battery Extension Wire (Part
DFFA013)
attached
4.8V, 300mAh receiver battery
(2) Servo mounting decals (Clear, 37mm square)
Velcro strips
1.
Remove canopy by gripping it near wing and
raising the right side as shown. This allows
canopy to "hinge" open lengthwise.
2.
Insert servos into molded pockets and route wire
leads through provided cutouts and into receiver
compartment.
3.
Apply provided servo mounting decals over each
servo as shown. Using a sharp hobby knife, trim
away the small area of decal covering the
Balance Locators beside the servo wire cutouts.
DO NOT remove the raised Balance Locator
lines, as these will be used for final balancing of
the model.
5.
