4.
Apply 50mm-long x 13mm-wide Velcro strips to battery and inside fuselage battery compartment. Note
that each large piece of Velcro is split down the middle to make the 13mm-wide strips. The Velcro allows
the battery to be adjusted fore and aft during final balancing. Use the remaining Velcro for mounting
receiver or a spare battery.
5.
For now, mount battery in the most forward position.
6.
Twist the servo wires together for a neater installation and then plug both elevon servo plugs into the proper
receiver channel ports (as determined in "Radio Gear Setup").
7.
Install receiver as shown. You can use the extra Velcro or a bit of double-sided tape if you like.
8.
Replace canopy and check it for proper fit. If necessary, tidy up your wiring so that it does not interfere
with fit of canopy.
6.