Draytek VigorAP 903, User Manual

Page: 48 / 153

42
to 64.
Enable Client Limit per
SSID Define the maximum number of wireless stations per SSID which try to
connect to Internet through Vigor device. The number you can set is from
3 to 64.
Mode At present, VigorAP 903 can connect to 11b only, 11g only, 11n only, Mixed
(11b+11g), Mixed (11g+11n) and Mixed (11b+11g+11n) stations
simultaneously. Simply choose Mixed (11b+11g+11n) mode.
Channel Means the channel of frequency of the wireless LAN. You may switch
channel if the selected channel is under serious interference. If you have
no idea of choosing the frequency, please select AutoSelect to let system
determine for you.
Extension Channel With 802.11n, there is one option to double the bandwidth per channel.
The available extension channel options will be varied according to the
Channel selected above. Configure the extension channel you want.
Enable 2 Subnet
(Simulate 2 APs) Check the box to enable the function for two independent subnets. Once
you enable this function, LAN-A and LAN-B would be independent. Next,
you can connect one router in LAN-A, and another router in LAN-B. Such
mechanism can make you feeling that you have two independent
AP/subnet functions in one VigorAP 903.
If you disable this function, LAN-A and LAN-B ports are in the same
domain. You could only connect one router (no matter connecting to
LAN-A or LAN-B) in this environment.
Hide SSID Check it to prevent from wireless sniffing and make it harder for
unauthorized clients or STAs to join your wireless LAN. Depending on the
wireless utility, the user may only see the information except SSID or just
cannot see any thing about VigorAP 903 while site surveying. The system
allows you to set four sets of SSID for different usage.
SSID Set a name for VigorAP 903 to be identified. Default settings are
DrayTek-LAN-A and DrayTek-LAN-B. When Enable 2 Subnet is enabled,
you can specify subnet interface (LAN-A or LAN-B) for each SSID by using
the drop down menu.
Subnet Choose LAN-A or LAN-B for each SSID. If you choose LAN-A, the wireless
clients connecting to this SSID could only communicate with LAN-A.
Isolate Member Check this box to make the wireless clients (stations) with the same SSID
not access for each other.
VLAN ID Type the value for such SSID. Packets transferred from such SSID to LAN
will be tagged with the number.
If your network uses VLANs, you can assign the SSID to a VLAN on your
network. Client devices that associate using the SSID are grouped into this
VLAN. The VLAN ID range is from 3 to 4095. The VLAN ID is 0 by default, it
means disabling the VLAN function for the SSID.
PHY Mode Data will be transmitted via HTMIX mode.
Each access point should be setup to the same Phy Mode for connecting
with each other.